Filter
Top Products
Chapter 19 HTTP Redirect
ISG50 User’s Guide
333
Note: You can configure up to one HTTP redirect rule for each (incoming) interface.
Figure 219 Configuration > Network > HTTP Redirect
The following table describes the labels in this screen.
19.2.1 The HTTP Redirect Edit Screen
Click Network > HTTP Redirect to open the HTTP Redirect screen. Then click the Add or Edit
icon to open the HTTP Redirect Edit screen where you can configure the rule.
Figure 220 Network > HTTP Redirect > Edit
Table 104 Configuration > Network > HTTP Redirect
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can
modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ISG50 confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
# This field is a sequential value, and it is not associated with a specific entry.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Name This is the descriptive name of a rule.
Interface This is the interface on which the request must be received.
Proxy Server This is the IP address of the proxy server.
Port This is the service port number used by the proxy server.
Apply Click Apply to save your changes back to the ISG50.
Reset Click Reset to return the screen to its last-saved settings.