Filter
Top Products
Chapter 52 System
ISG50 User’s Guide
703
The following table describes the labels in this screen.
Table 281 Configuration > System > SNMP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the ISG50
using this service.
Server Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows
all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from
the management station. The default is private and allows all requests.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
Service Control This specifies from which computers you can access which ISG50 zones.
Add Click this to create a new entry. Select an entry and click Add to create a new
entry after the selected entry. Refer to Table 275 on page 683 for details on the
screen that opens.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s
settings.
Remove To remove an entry, select it and click Remove. The ISG50 confirms you want to
remove it before doing so. Note that subsequent entries move up by one when
you take this action.
Move To change an entry’s position in the numbered list, select the method and click
Move to display a field to type a number for where you want to put it and press
[ENTER] to move the rule to the number that you typed.
# This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ISG50’s (non-configurable)
default policy. The ISG50 applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule
that traffic will match so the ISG50 will not have to use the default policy.
Zone This is the zone on the ISG50 the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed
or denied to access.
Action This displays whether the computer with the IP address specified above can
access the ISG50 zone(s) configured in the Zone field (Accept) or not (Deny).
Apply Click Apply to save your changes back to the ISG50.
Reset Click Reset to return the screen to its last-saved settings.