Filter
Top Products
Chapter 55 File Manager
ISG50 User’s Guide
730
Apply Use this button to have the ISG50 use a specific configuration file.
Click a configuration file’s row to select it and click Apply to have the ISG50 use
that configuration file. The ISG50 does not have to restart in order to use a
different configuration file, although you will need to wait for a few minutes while
the system reconfigures.
The following screen gives you options for what the ISG50 is to do if it encounters
an error in the configuration file.
Figure 492 Maintenance > File Manager > Configuration File > Apply
Immediately stop applying the configuration file - this is not recommended
because it would leave the rest of the configuration blank. If the interfaces were
not configured before the first error, the console port may be the only way to
access the device.
Immediately stop applying the configuration file and roll back to the
previous configuration - this gets the ISG50 started with a fully valid
configuration file as quickly as possible.
Ignore errors and finish applying the configuration file - this applies the
valid parts of the configuration file and generates error logs for all of the
configuration file’s errors. This lets the ISG50 apply most of your configuration
and you can refer to the logs for what to fix.
Ignore errors and finish applying the configuration file and then roll back
to the previous configuration - this applies the valid parts of the configuration
file, generates error logs for all of the configuration file’s errors, and starts the
ISG50 with a fully valid configuration file.
Click OK to have the ISG50 start applying the configuration file or click Cancel to
close the screen
# This column displays the number for each configuration file entry. This field is a
sequential value, and it is not associated with a specific address. The total
number of configuration files that you can save depends on the sizes of the
configuration files and the available flash storage space.
Table 291 Maintenance > File Manager > Configuration File (continued)
LABEL DESCRIPTION