Filter
Top Products
Chapter 27 Global PBX Settings
ISG50 User’s Guide
434
The following table describes the labels in this screen.
Table 142 Configuration > PBX > Global > Feature Code
LABEL DESCRIPTION
Group Pickup This code is used to pick up calls for your extension from a different extension in the same
authority group.
Call Transfer This code is used to transfer calls.
Direct Pickup This code is used to pick up calls for your extension from a different extension.
Follow Me On This code is used to turn the Follow Me feature on for this extension.
Follow Me Off This code is used to turn the Follow Me feature off for this extension.
Voice Mail This code is used to access voice mail on the ISG50.
Mobile Extension
On
This code is used to activate the mobile extension feature from your regular telephone
extension.
Once activated, calls are sent both to your extension and to the phone designated as the
mobile extension.
For example, if your IP PBX extension has been configured to use your cell phone as a
mobile extension, you can dial into the ISG50 with your cell phone and then enter this
code. That tells the ISG50 to send all calls to your extension to your cell phone.
Mobile Extension
Off
This code is used to turn off the mobile extension feature from your regular telephone
extension. Calls are no longer sent simultaneously to both your extension and the mobile
extension; they are sent strictly to your regular extension.
For example, if all calls currently incoming to your extension are sent to your cell phone,
you can dial into the ISG50 and then enter this code. That tells the ISG50 to stop sending
calls intended for your extension to your cell phone.
Mobile Extension
Auto
This code changes the mobile extension feature’s setting from off to on or from on to off.
For example, if you use this code when the mobile extension feature is turned on, it turns
it off. If you use this code when the mobile extension feature is turned off, it turns it on.
Call Recording On
Demand
Use this code to start recording the current call. The on-demand call recording option
must also be enabled in the call recording setup. See Section 35.2 on page 545.
Second Dial This code is used to get a second dial tone. When you enter the Second Dial code from
your phone, the ISG50 opens a connection to the outside telephone network.
For example, in many office environments you cannot access an outside dial tone unless
you press “9” or “0” first. A number dialed without such a prefix is considered internal and
thus routed to the appropriate extension. If that extension does not exist, an error is
returned.
Leave this field blank if you do not require people using your telephone network to dial a
specific number to access an outside line.
Note: You only need to enable this function if your phone network is analog-based (such as
one that uses FXS). Digital phone systems such as SIP and BRI do not require it.
Note: If you enable this function on a digital network, a person does not need to use the
Second Dial number in conjunction with any phone numbers dialed.
Internal Operator
(0 or 9)
Use the first field of this code to set which number (0 or 9) internal users dial to reach the
internal operator. Use the second field to specify the operator’s extension number. The
extension must already exist in the ISG50.
Apply
Click this to save your changes.
Reset Click this to set every field in this screen to its last-saved value.