Filter
Top Products
Chapter 32 LCR
ISG50 User’s Guide
524
Note: Only the Add Dial Condition screen is shown. In the Edit Dial Condition screen,
some of the fields are read-only.
Figure 345 Configuration > PBX > Outbound Line Management > LCR > Add > Add
Each field is described in the following table.
Table 185 Configuration > PBX > Outbound Line Management > LCR > Add > Add
LABEL DESCRIPTION
LCR Name This field displays the name of the outbound dialing rule that this dialing condition applies
to.
Dial Condition
Create the criteria for using this outbound dialing rule. The criteria can be
• a specific number - for example “55555555”; in this case the number dialed by users
must match this string exactly.
• any number starting with a specified pattern of digits - for example “0.”, “555.”, “011.”
and so on; in this case the number dialed must match the digits before the period “.”
and it doesn’t matter what follows. For example dialing “0222-2222” matches the
dialing condition “0.”.
You can also specify a range for digits within a dial condition. You can:
•use the letters X, Z, N to specify a range of numbers to match. X represents the range
0-9, Z represents the range 1-9 and N represents the range 2-9.
• use brackets to specify an allowed range for a dialed digit. For example [0-8] or [0-
46-9], in the second example 5 is not allowed.
Use the Right button to test if the dial condition is in acceptable format.
Note: You should make sure to create unique dial conditions for each LCR. The ISG50 is
not able to distinguish between LCRs if they have the same dial condition.
Dial Parameter Use this section to configure what the ISG50 does with the phone numbers this LCR sends
to this outbound line group.
Edit
Double click the entry or select it and click Edit to modify it.
Dial Number View Click this to display the phone number the ISG50 has the outbound line group send for
the number in the Dial Number field.
#
This field displays the index number of a dial parameter.
Channel This column identifies the outbound line groups for this outbound dialing rule (LCR).
Offset
Specify how many initial digits of the dialed number should not be included in the number
going out of the ISG50.
Length
Specify whether the number dialed should be limited in length. If you set a limit, the
ISG50 cuts off numbers which extend beyond the limit.