Filter
Top Products
Appendix B
Error Messages
B-1 INTRODUCTION This appendix provides a listing of error messages that appear on the
373XXA display or that are written to the internal software Service
Log.
B-2 OPERATIONAL ERROR
MESSAGES
Table B-1 provides a listing and description of the operational error
messages. For the most part, these errors are displayed only on the
373XXA display and are caused by incorrectly operating the 373XXA.
B-3 DISK RELATED ERROR
MESSAGES
Table B-2 provides a listing and description of the disk-related-error
messages. The numbered errors in this group are also written to the
Service Log, since they may indicate system problems.
B-4 GPIB RELATED ERROR
MESSAGES
Table B-3 provides a listing and description of GPIB-related error mes-
sages. These errors are entered in the Service Log and output as part
of the response of OGE/OGL commands.
B-5 SERVICE LOG ERROR
MESSAGES
Table B-4 provides a listing of the error messages that are written to
the internal system service log. Some of these messages may occur as
a result of incorrectly programming the 373XXA. This includes the
GPIB errors, 7204–7207, and errors in the 5000 range, RF Power. The
RF Power errors may be triggered when setting the 373XXA power to
a value greater than its reset level. This feature of the 373XXA lets
you take advantage of all available power; however, accuracy cannot
be guaranteed when power is unleveled. Refer to Chapter 5, para
-
graph 5-6 for additional guidance in interpreting these error codes.
The error messages in Table B-4 are numbered and organized as fol
-
lows:
0000 - 0099 These messages generally indicate status or a pass/fail result of a Pe
-
ripheral or Self test.
0100 - 3999 These messages primarily indicate a self-test failure with the suspect
assembly number being the two high-order digits. For example, error
0111 indicates test 11 for the A1 assembly has failed, similarly, error
0814 is related to the A8 assembly test #14, and error 2138 is related
to the A21 assembly test #38.
Since these errors are primarily self-test errors, they do not get dis
-
played but only get written to the service log. Any exceptions to this
373XXA MM B-3