Filter
Top Products
Verification Kits The ANRITSU Verification Kits listed below are used in conjunction with
the 37XXX Performance Verification Software (above). See Chapter 4, Per
-
formance Verification, for further information.
N Verification Kit (Model 3663)
Contains precision N Connector components with characteristics that
are traceable to the NIST.
Use for Models 37317A and below with Option 7N and 7 NF.
3.5 mm Verification Kit (Model 3666)
Contains precision 3.5 mm Connector components with characteristics
that are traceable to the NIST.
Use for Models 37347A and below with Option 7A.
GPC-7 Verification Kit (Model 3667)
Contains precision GPC-7 Connector components with characteristics
that are traceable to the NIST.
Use for Models 37317A and below with Option 7A.
K Verification Kit (Model 3668)
Contains precision K Connector components that are traceable to the
NIST.
V Verification Kit (Model 3669B)
Contains precision V Connector components that are traceable to the
NIST.
Test Fixtures/ Aids The test fixtures and test aids listed below are available through your lo-
cal ANRITSU Sales or Service Center:
Rear Panel Printer Port Test Fixture (B39553).
This test fixture is used to check out digital printer interface circuits
on the rear panel assembly.
GPIB Cable (2100-2).
This cable is used to check out digital GPIB interface circuits on the
rear panel assembly.
Failed Assembly
Exchange Program
The exchange program allows a customer to quickly exchange a failed
subassembly for a factory refurbished, fully system-tested and unit that is
under warranty. This results in significant time and price savings as com
-
pared with ordering a new assembly.
Refer to Chapter 2, Replaceable Parts, for a complete list of exchange
-
able assemblies for all Series 373XXA models.
NOTE
When sending a failed assembly to the factory for ex
-
change, a copy of the Service Log must always accom
-
pany the failed assembly. Refer to Chapter 2, Replaceable
Parts, for further information.
SERVICE SUPPORT GENERAL INFORMATION
1-8 373XXA MM