Filter
Top Products
3 Installing a New G700 with an S8300: Configure the G700 Media Gateway
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
127
6. Type set interface mgp <vlan> <ip_address> <netmask> to assign an IP
address to the G700 Media Gateway. <vlan> is the vlan to be established on the customer’s
local network. This is usually
1. The <ip_address> <netmask> is the assigned addresses
for the G700 Media Gateway.
!
CAUTION:
If this G700 contains an S8300 configured as an LSP, use the VLAN administered on the
primary controller.
7. At the MG-???-n(configure)# prompt, type reset mgp.
A system prompt asks to confirm the reset.
8. Select Yes at the dialog box that asks if you want to continue.
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
9. Log in again at the Welcome to P330 menu.
10. At the P330-1(configure)# prompt, type session mgp.
11. At the MG-???-1(super)# prompt, type configure to reach the configuration level of the
command line interface.
12. Type show interface mgp to verify that the G700 Media Gateway has the correct IP
address.
Assign the Default IP Route to the G700 Media Gateway
1.
At the MG-???-n(configure)# prompt, type set ip route <destination>
<netmask> <gateway_ip_address>. Both <destination> and <netmask> are
0.0.0.0 for the default gateway. <gateway_ip_address> is the IP address of the local
network segment.
2. Type show ip route mgp to view the results.
3. Repeat step 1 for additional ip routes, if needed. Usually, only a default route is needed. Refer to
your planning document.
Assign IP Addresses to the VoIP Resources
From the G700 Media Gateway Processor command line interface, you will assign IP addresses to
the VoIP resource resident on the G700 Media Gateway and to any installed MM760 VoIP Media
Modules.
1. At the MG-???-n(configure)# prompt, type set interface voip <number> <ip
address>
<number> is the slot number of the VoIP media module. v0 designates the VoIP resource
resident on the G700 Media Gateway motherboard. The MM760 VoIP Media Modules are
designated according the slot (for example,
v1, v2, v3, v4) in which the Media Module has been
installed. <ip address> is the IP address of the VoIP resource.