Filter
Top Products
4 Installing a New G700 without an S8300: Administer Communication Manager
202
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
Administer the LSP Form
If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable the
LSPs to get translations updates from the primary controller. Once the LSPs are successfully entered
on the LSP form, their status can be viewed with the display lsp command.
Note: The LSP node names must be administered on the node-names-ip form before
they can be entered on the LSP form.
Add LSP names to the LSP form
1.
At the SAT prompt, type change lsp to open the LSP form.
LSP Screen
2. Enter the node name for each LSP supported by the primary controller and submit the form.
To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT session.
!
CAUTION:
Before administering a media gateway, make sure that the gateway has been fully
configured.
Add Media Gateway
1. At the SAT prompt, type add media-gateway <number>
where <number> is the gateway number from 1 to n . (n is 50 for an S8300 and 250 for an
S8700).
change lsp Page 1 of 16
LOCAL SURVIVABLE PROCESSOR
Number NAME IP Address Currently Translations
Available? Updated
1 node-10-LSP
__ 192.168.1.51 y 13:06 5/4/2003
2 ____________ n
3 ____________ n
4 ____________ n
5 ____________ n
6 ____________ n
7 ____________ n
8 ____________ n
9 ____________ n
10 ____________ n
11 ____________ n
12 ____________ n
13 ____________ n
14 ____________ n
15 ____________ n
16 ____________ n