Filter
Top Products
4 Installing a New G700 without an S8300: Administer Communication Manager
200
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
Administer IP Interfaces
Define the IP interfaces of the S8700 port network CLAN boards
Note: This should have already been established as a part of normal S8700 installation.
1. Type change ip-interfaces to open the IP Interfaces screen.
IP Interfaces Screen
2. Complete the fields as described the in the following table.
change ip-interfaces Page 1 of 6 SPE B
IP INTERFACES
Enable Net
Eth Pt Type Slot Code Sfx Node Name Subnet Mask Gateway Address Rgn
y C-LAN 02C18 TN799 C st7clan 255.255.0 .0 172.23 .23 .254 80
n MEDPRO 02C08 TN802 B st7_mp1 255.255.255.0 192.168.22 .254 6
y MEDPRO 02C11 TN2302 st7_prowler1 255.255.0 .0 172.23 .23 .254 7
y C-LAN 02B17 TN799 C st7clan3 255.255.0 .0 172.23 .23 .254 6
y C-LAN 01A06 TN799 C st7clan4 255.255.0 .0 172.23 .23 .254 80
y MEDPRO 02C13 TN2302 st7_prowler6 255.255.0 .0 172.23 .23 .254 1
y MEDPRO 02C15 TN2302 st7_prowler7 255.255.0 .0 172.23 .23 .254 80
n MEDPRO 02C16 TN2302 st7_prowler8 255.255.0 .0 172.23 .23 .254 80
Field Conditions/Comments
Enable Eth Pt The Ethernet port must be enabled (y) before it can be used.
The port must be disabled (n) before changes can be made to
its attributes on this screen.
Type Either C-LAN.
Slot The slot location for the circuit pack.
Code Display only. This field is automatically populated with TN799
for C-LAN.
Sfx Display only. This field is automatically populated.
Node name The unique node name for the IP interface. The node name
here must already be administered on the Node Names
screen.
1 of 2