Filter
Top Products
C Equipment List:
300
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
DEF DS1 LOOPBACK JACK 700A
Provides the ability to remotely troubleshoot the MM 710 T1/E1 Media Module. It
is required for any customer with a maintenance contract and highly
recommended for any other customer.
Material Code: 107988867 Apparatus Code: None Required for any customer
with a maintenance
contract and an MM710
T1/E1 Media Module,
highly recommend for
other customers to avoid
expensive technician
visits.
MM711 Analog Media Module
The MM711 Analog Media Module supports eight analog interfaces allowing the
connectivity of Loop Start, Ground Start, Analog DID trunks, and 2-wire analog
Outgoing CAMA E911 trunks. As well, the MM711 Analog Media Module allows
connectivity of analog, tip/ring devices such as single line telephones, modems
or group 3 fax machines. Each port may be configured as either a trunk interface
or a station interface.
Also included is support for caller ID signaling, ring voltage generation for a
variety of international frequencies and cadences and administrable line
termination styles.
Material Code: 170899 Apparatus Code: MM711 Optional
ComCode (for Services Ordering Only): 700221146
MM712 DCP Media Module
The MM712 DCP Media Module allows connectivity of up to 8 two-wire DCP
voice terminals. MM712 will not support 4-Wire DCP telephones.
Signal timing specifications for the MM712 support TDM Bus Timing in receive
and transmit modes. The G700 Media Gateway supplies only +5 VDC and –48
VDC to the MM712 Media Module. Any other required voltages must be derived
on the module.
Loop range secondary protection is provided on the MM712. The MM712 is also
self-protecting from an over current condition on a tip and ring interface.
Material Code: 170898 Apparatus Code: MM712 Optional
ComCode (for Services Ordering Only): 700221153
Table 14. Equipment List: Media Modules Continued
Media Modules
2 of 3