Filter
Top Products
4 Installing a New G700 without an S8300: Administer Communication Manager
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
203
The S8300 displays the Media Gateway screen.
Add Media Gateway Screen
2. Complete the Name field with the hostname assigned to the G700 Media Gateway.
3. Complete the Identifier field with the serial number of the G700 Media Gateway. You can
obtain the serial number by typing the show system command at the MGP command line.
!
CAUTION:
Be sure the serial number for the G700 Media Gateway you enter in this procedure matches
exactly the serial number displayed in the show system command. The serial number is
case-sensitive, and if entered incorrectly, will prevent the S8300 Media Server from
communicating with the G700 Media Gateway.
4. Complete the Network Region field with the value supplied in the planning documentation.
5. If specifically requested by the customer or your planning documents, type gateway-
announcements
in the V9 field. This field allows you to enable announcements on the G700
Media Gateway. V9 is a virtual slot. There is no announcement board associated with it. The
announcements for the G700 are available in the G700 firmware and are administered in the same
way as announcements on the TN2301 circuit pack used on S8700 port networks.
If there are multiple G700 Media Gateways sharing announcements, then enable announcements
on the G700 whose trunks will receive the announcements most often.
6. Press F3 (ENTER) to save your changes.
If properly administered, the G700 should register with the primary controller within 1–2
minutes. The IP Address, MAC Address, and Module Type fields are populated automatically
after the G700 Media Gateway registers with the server.
change media-gateway 1 Page 1 of 1
MEDIA GATEWAY
Number: 1
Name: Swainsons Identifier: 012X06230551
IP Address: MAC Address:
Network Region: 1 Location: 1
Site Data: Registered? n
Slot Module Type
V1:
V2:
V3:
V4:
V8:
V9: