Filter
Top Products
1 Roadmap and Reference: Navigational Aid for CLI Commands
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
59
Navigational Aid for CLI Commands
This section describes a few Command Line Interface commands that you will need to navigate between the
processors on the G700.
Log in to the P330 stack processor. Default mode is "Supervisor" with a P330-1(super)# command-line
prompt.
The command-line prompts in an MGP session use the media gateway’s name that is assigned when it is
configured.
You can telnet to another processor from a current telnet session.
Command Purpose Prompt
super change to supervisor
mode
P330-1(super)#
or <MG name>-1(super)#
configure change to configura-
tion mode
P330-1(configure)#
or <MG name>-1(configure)#
session <module #> mgp
(from a stack processor session)
open a CLI session on
the mgp processor
<MG name>-1(super)#
session <module #> stack
(from an MGP session)
open a CLI session on
the stack processor
P330-1(super)#
session icc
(from an MGP session)
open a CLI session on
the S8300 processor
craft@<host name>>
session <#> open a session on the
stack processor in
module (i.e. another
G700)<#> in the stack
P330-<#>(super)#
exit close the current ses-
sion (and revert to the
previous session)
<command>
help displays help for <com-
mand>