Filter
Top Products
4 Installing a New G700 without an S8300: Configure the G700
168
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
Configure the G700
Note: If you are using the Avaya Gateway Installation Wizard (GIW), the GIW performs
tasks automatically in the
Assign the IP Addresses of the G700 Media Gateway
Components, Set up the Controller List for the G700 Media Gateway, Check for IP
Connections, and Set the LSP Transition Points sections. However, the GIW does not
configure an X330 Expansion module. This task you must still perform as
described in this document.
For a new installation of a G700 Media Gateway, you must complete the following configuration tasks:
• Assign IP addresses to the G700 processors
• Assign IP routes for the gateway
• Set up the controller list
Assign the IP Addresses of the G700 Media
Gateway Components
Note: If you are using the Avaya Gateway Installation Wizard (GIW), the GIW performs
this task automatically.
This section describes how to assign the IP addresses and IP routes to the G700 Media Gateway and
its components. The IP addresses should be available to you on the IP Addressing Planning Form.
The command arguments you will be supplying include:
vlan –Virtual Local Area Network: a defined network segment that
allows users on that segment to have priority services in sharing
information with each other.
If the network is not using VLANs, the VLAN should be 1.
Otherwise, use the VLAN numbers indicated in your planning
forms. The G700 Media Gateway should be assigned the same
VLAN as the VLAN to which the Ethernet ports are connected. The
P330 stack processor might or might not be assigned to the
customer’s network management VLAN.
IP address –the unique identifier assigned to an entity on the customer LAN
netmask –the subnet mask for the customer’s LAN segment
destination –distant networks that the IP route command needs to send
packets to. Usually generalized to 0.0.0.0 for networks other than
the local segment.
default gateway –the gateway the ip route command specifies to get to the distant
networks