Filter
Top Products
4 Installing a New G700 without an S8300: Administer Communication Manager
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
205
If the G700 fails to register, two common causes might be:
- The serial number added as the identifier for the G700 is wrong. To check, log back into the
G700 gateway and type show system. Check the serial number that appears.
- There is no IP connection between the G700 and the S8300. To check, type show mgc and
then ping mgp <controller_address>.
Enable Announcements, If Necessary
1.
Only if specifically requested by the customer or your planning documents, at the SAT prompt,
type enable announcement-board <gateway_number> V9, where
<gateway_number> is the number of the G700 Media Gateway you just added and
V9 is the
virtual slot (for example,
2V9 means Media Gateway number 2, slot V9.
2. Press ENTER to enable announcements.
The system displays the message Command successfully completed.
Save Communication Manager Translations
Save translations again after all Communication Manager administration is complete.
- At the SAT prompt, type save translations.