Filter
Top Products
3 Installing a New G700 with an S8300: Administer Communication Manager
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
139
Administer Communication Manager
Perform one of the following two administration procedures in this section:
• The Primary Controller is an S8300
, or
• The Primary Controller is an S8700 (the S8300 Is an LSP)
The Primary Controller is an S8300
!
CAUTION:
This administration applies only to an S8300 that serves as the primary controller for the
target G700. The S8300 primary controller can be in the target G700 or in another, possibly
remote, G700. If the S8300 is an LSP, do not administer Communication Manager on it.
Translations are automatically copied to the LSP from the S8300 primary controller.
If the primary controller is an S8700, skip this section and go to “The Primary Controller is an S8700 (the
S8300 Is an LSP)” on page 145
This document covers only the administration of Communication Manager required for the G700 Media
Gateway to communicate with the primary controller over a customer’s network. For the majority of
administration required, see ‘‘Administrator’s Guide to Avaya™ Communication Manager, 555-233-506,’’
or ‘‘Administration for Network Connectivity for Avaya™ Communication Manager, 555-233-504.’’
In this section, you will use the SAT interface to:
• Assign Node Names for LSPs
• Define the IP Network Region
• Add a Media Gateway.
!
CAUTION:
Before continuing, be sure you have saved translations in Communication Manager.
Reset the System
1.
Telnet to the S8300, log in, and open a SAT session (type sat or dsat).
2. At the SAT prompt, type reset system 4
The system reboots.
1. After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assign Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specifiied on the Node Names form.
Assign node names
1. At the S8300 SAT prompt, type change node-names ip to open the Node Names screen.