Filter
Top Products
5 Upgrading an Existing G700 with an S8300: Complete the Upgrade Process (S8300 is the Primary Controller)
238
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
If you do not get a login prompt and see the following message:
Warning: Translation corruption detected
follow the normal escalation procedure for translation corruption before continuing the upgrade.
Back up the System
Back up the system as you did before the upgrade. See “Back up the System” on page 215.
Logoff the SAT session.
Re-enable Alarm Origination
1.
At the command prompt, type almenable -d b -s y, where
-d b sets the dialout option to both (numbers)
-s y enables SNMP alarm origination
2. Type almenable (without any options) to verify that alarm origination has been disabled.
This completes the upgrade process.