Filter
Top Products
4 Installing a New G700 without an S8300: Configure the G700
174
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
All LEDs will flash. As the unit powers up, self-tests will be run. When the G700 mpg or P330
stack processor has reset, login again to continue.
4. Login at the Welcome to P330 menu.
The prompt P330-1(super)# appears.
5. Type configure to obtain the P330-1(configure)# prompt.
Establish the IP Routing for the Stack
1.
Type show interface inband to verify that the Avaya P330 stack server (Layer 2
Switching Processor) has the correct address.
2. Type set ip route 0.0.0.0 <default-gateway> to set the destination and gateway
IP addresses. You will find these addresses in the planning documentation.
<default-gateway> is the IP address of the customer’s network gateway.
3. Press Enter to save the destination and gateway IP addresses.
4. Type show ip route.
The route net and route host tables appear. Verify that the information is correct.
Check the serial number of the G700 Media Gateway processor
After you have configured the P330 stack processor, you will assign an IP address to the G700
Media Gateway Processor (MGP). Your first step is to check the serial number of the MGP.
1. At the P330-1(configure)# prompt, type session mgp.
2. At the MG-???-1(super)# prompt, type show system to list various attributes of the
G700.
The system displays a list of attributes, as shown in the following example: