IPv6 Multicast Commands 1181
Default Configuration
The default join/prune interval is 60 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 pim join-prune-interval 90
ipv6 pim register-rate-limit
Use the ipv6 pim register-rate-limit command to set a limit on the maximum
number of PIM register messages sent per second for each (S,G) entry. Use
the no form of this command to return the limit to its default value (0).
Syntax
ipv6 pim register-rate-limit
register-rate-limit
no ipv6 pim register-rate-limit
Parameter Description
Default Configuration
The default threshold is 0. This indicates that the register limit is infinite.
Command Mode
Global Configuration mode
Parameter Description
register-rate-limit The PIM register message limit in kilobytes per second. Range
0–2000 Kbps.
2CSPC4.X8100-SWUM102.book Page 1181 Friday, March 15, 2013 8:56 AM