IPv6 Access List Commands 517
Default Configuration
This command has no default configuration.
Command Modes
Global Configuration mode
Interface Configuration (Ethernet, Port-channel, VLAN) mode
User Guidelines
This command specified in 'Interface Config' mode only affects a single
interface, whereas the 'Global Config' mode setting is applied to all interfaces.
Example
The following example attaches an IPv6 access control list to an interface.
console(config-if-1/0/1)#ipv6 traffic-filter DELL_IP6 in
show ipv6 access-lists
Use the show ipv6 access-lists command in User EXEC and Privileged EXEC
mode to display an IPv6 access list and all of the rules that are defined for the
IPv6 ACL. Use the [
name
] parameter to identify a specific IPv6 ACL to
display.
Syntax
show ipv6 access-lists [
name
]
Parameter Description
Default Configuration
There is no default configuration for this command.
Parameter Description
name
The name used to identify the IPv6 ACL.
Time Range Name Displays the name of the time-range if the IPv6 ACL rule has
referenced a time range.
Rule Status Status (Active/Inactive) of the IPv6 ACL rule.
2CSPC4.X8100-SWUM102.book Page 517 Friday, March 15, 2013 8:56 AM