UDLD Commands 775
udld message time
Use the udld message time command in Global Config mode to configure
the interval between the transmission of UDLD probe messages on ports that
are in the advertisement phase.
Use the no form of the command to return the message transmission interval
to the default value.
Syntax
udld message time <message-interval>
no udld message time
Parameter Description
Default Configuration
The default message transmit interval is 15 seconds.
Command Mode
Global Config mode
User Guidelines
Lower message time values will detect the unidirectional links more quickly
at the cost of higher CPU utilization.
The message interval is also used to age out UDLD entries from the internal
database. UDLD entries are removed after three times the message interval
and the discovery process starts again.
udld timeout interval
Use the udld timeout interval command in Global Config mode to configure
the interval for the receipt of ECHO replies.
Parameter Description
message-interval UDLD message transmit interval in seconds. Range is 7 to 90
seconds.
2CSPC4.X8100-SWUM102.book Page 775 Friday, March 15, 2013 8:56 AM