Using the CLI 190
Starting the CLI
To begin running the CLI, perform the following steps:
NOTE: This procedure is for use on the console line only.
NOTE: The Easy Setup Wizard is available only when the system is in default state
with no user configuration saved previously.
1
Start the switch and wait until the startup procedure is complete and the
User EXEC mode is entered. The prompt
console>
is displayed.
VLAN From Global
Configuration
mode, use the
interface vlan
command.
console(config-if-vlan
vlan-
id
)#
To exit to Global
Configuration
mode, use the
exit command,
or press
<Ctrl>+<Z>
to Privileged
EXEC mode.
Tunnel From Global
Configuration
mode, use the
interface tunnel
command. Or, use
the abbreviation
interface tu.
console(config-tunnel
tunnel-
id
)#
To exit to Global
Configuration
mode, use the
exit command,
or press
<Ctrl>+<Z>
to Privileged
EXEC mode.
Loopback From Global
configuration mode,
use the interface
loopback
command. Or, use
the abbreviation
interface lo.
console(config-
loopback
loopback-id
)#
To exit to Global
Configuration
mode, use the
exit command,
or press
<Ctrl>+<Z>
to Privileged
EXEC mode.
Table 2-5. Navigating CLI Command Modes
(continued)
Command Mode Access Method Command Prompt Exit or Access
Previous Mode
2CSPC4.X8100-SWUM102.book Page 190 Friday, March 15, 2013 8:56 AM