Filter
Top Products
Using the CLI 195
NOTE: In the following Easy Setup Wizard example, the possible user options are
enclosed in
[ ]. Also, where possible, default values are enclosed in []. If the user
enters <Return> with no options defined, the default value is accepted. Help text is
in parentheses.
After the switch completes the POST and is booted, the following dialog
appears:
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch
configuration, and gets you up and running as quickly
as possible. You can skip the setup wizard, and enter
CLI mode to manually configure the switch. You must
respond to the next question to run the setup wizard
within 60 seconds, otherwise the system will continue
with normal operation using the default system
configuration.Note: You can exit the setup wizard at
any point by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within 60 seconds)? [Y/N] y
Step 1:
The system is not setup for SNMP management by
default. To manage the switch using SNMP (required for
Dell Network Manager) you can:
o Set up the initial SNMP version 2 account now.
o Return later and setup other SNMP accounts. (For
more information on setting up an SNMP version 1 or 3
account, see the user documentation).
Would you like to setup the SNMP management interface
now? [Y/N] y
To setup the SNMP management account you must specify
the management system IP address and the "community
string" or password that the particular management
system uses to access the switch. The wizard
automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell
2CSPC4.X8100-SWUM102.book Page 195 Friday, March 15, 2013 8:56 AM