QoS Commands 667
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition based on the "ip"
protocol name keyword.
console(config-classmap)#match protocol ip
match source-address mac
Use the match source-address mac command in Class-Map Configuration
mode to add to the specified class definition a match condition based on the
source MAC address of the packet.
Syntax
match source-address mac
address
macmask
•
macaddr
— Specifies any valid layer 2 MAC address formatted as six two-
digit hexadecimal numbers separated by colons.
•
macmask
— Specifies a layer 2 MAC address bit mask formatted as six
two-digit hexadecimal numbers separated by colons. This bit mask does
not need to be contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds to the specified class definition a match
condition based on the source MAC address of the packet.
2CSPC4.X8100-SWUM102.book Page 667 Friday, March 15, 2013 8:56 AM