Filter
Top Products
Command Groups 132
IPv6 Multicast
show ip pim interface
Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
UE or
PE
show ip pim neighbor
Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
UE or
PE
show ip pim rp hash
Displays the rendezvous point (RP) selected for
the specified group address.
UE or
PE
show ip pim rp mapping
Displays the mappings for the PIM group to the
active rendezvous points (RPs).
UE or
PE
a. For the meaning of each Mode abbreviation, see
Mode Types
on page 81.
Command Description Mode
a
ipv6 pim (Global config)
Administratively enables PIMSM for IPv6
multicast routing
GC
ipv6 pim (VLAN Interface
config)
Administratively enables PIM-SM multicast
routing mode on a particular IPv6 router
interface.
IC
ipv6 pim bsr-border
Prevents bootstrap router (BSR) messages from
being sent or received through an interface.
IC
ipv6 pim bsr-candidate
Configures the router to announce its
candidacy as a bootstrap router (BSR).
GC
ipv6 pim dense
Administratively configures PIM dense mode
for IPv6 multicast routing.
GC
ipv6 pim dr-priority
Sets the priority value for which a router is
elected as the designated router (DR).
IC
ipv6 pim hello-interval
Administratively configures the PIM-SM Hello
Interval for the specified interface.
IC
ipv6 pim join-prune-interval
Administratively configures the interface
join/prune interval for the PIM-SM router.
IC
Command Description Mode
a
2CSPC4.X8100-SWUM102.book Page 132 Friday, March 15, 2013 8:56 AM