348 DHCP Layer 2 Relay Commands
show dhcp l2relay circuit-id vlan
Use the show dhcp l2relay circuit-id vlan command in Privileged EXEC
mode to display whether DHCP L2 Relay is globally enabled and whether the
DHCP Circuit-ID option is enabled on the specified VLAN or VLAN range.
Syntax
show dhcp l2relay circuit-id vlan
vlan-range
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay circuit-id vlan 300
DHCP L2 Relay is Enabled.
DHCP Circuit-Id option is enabled on the following VLANs:
300
Parameter Description
vlan-range Show information for the specified VLAN range. A range may
be a single VLAN ID or two VLAN IDs separated by a single
dash with no embedded spaces.
2CSPC4.X8100-SWUM102.book Page 348 Friday, March 15, 2013 8:56 AM