1340 OSPFv3 Commands
OSPF Admin Mode.......................... Enable
OSPF Area ID............................. 0.0.0.1
Router Priority.......................... 1
Retransmit Interval...................... 5
Hello Interval........................... 10
Dead Interval............................ 40
LSA Ack Interval......................... 1
Iftransit Delay Interval................. 1
Authentication Type...................... None
Metric Cost.............................. 10 (computed)
OSPF Mtu-ignore.......................... Disable
OSPF Interface Type...................... broadcast
State.................................... backup-
designated-router
Designated Router........................ 1.1.1.1
Backup Designated Router................. 2.2.2.2
Number of Link Events.................... 46
show ipv6 ospf neighbor
Use the show ipv6 ospf neighbor command in Privileged EXEC mode to
display information about OSPF neighbors. If a neighbor IP address is not
specified, the output displays summary information in a table. If an interface
or tunnel is specified, only the information for that interface or tunnel
displays. The information below only displays if OSPF is enabled and the
interface has a neighbor.
Syntax
show ipv6 ospf neighbor [interface-type interface-number] [neighbor-id]
2CSPC4.X8100-SWUM102.book Page 1340 Friday, March 15, 2013 8:56 AM