OSPFv3 Commands 1317
Example
Use the following command to enable OSPFv3.
console(config)#ipv6 router ospf
maximum-paths
Use the maximum-paths command in Router OSPFv3 Configuration mode
to set the number of paths that OSPF can report for a given destination.
Syntax
maximum-paths
maxpaths
no maximum-paths
•
maxpaths
— Number of paths that can be reported. (Range: 1-2)
Default Configuration
2 is the default value for
maxpaths
.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of paths that OSPF can report for a
destination to 1.
console(config)#ipv6 router ospf
console(config-rtr)#maximum-paths 1
nsf
Use this command to enable OSPF graceful restart. Use the no form of this
command to disable graceful restart.
2CSPC4.X8100-SWUM102.book Page 1317 Friday, March 15, 2013 8:56 AM