1184 IPv6 Multicast Commands
Syntax
ipv6 pim rp-candidate vlan
vlan-id group-address/prefixlength
no ipv6 pim rp-candidate vlan
vlan-id
• vlan-id—A valid VLAN ID value.
• group-address—The group address to display.
• prefixlength—This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–32)
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by
default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim rp-candidate vlan 6 ff1e::/64
ipv6 pim sparse (Global config)
Use the ipv6 pim sparse command to administratively configure PIM sparse
mode for multicast routing. Use the no form of this command to disable PIM
sparse mode.
Syntax
ipv6 pim sparse
no ipv6 pim sparse
Default Configuration
IPv6 PIM is disabled by default.
2CSPC4.X8100-SWUM102.book Page 1184 Friday, March 15, 2013 8:56 AM