776 UDLD Commands
Use the no form of the command to return the value to the default setting.
Syntax
udld timeout interval
timeout-interval
no udld timeout interval
Parameter Description
Default Configuration
The default timeout interval is 5 seconds.
Command Mode
Global Config mode
User Guidelines
This command sets the time interval used to determine if the link has
bidirectional or unidirectional connectivity. If no ECHO replies are received
within three times the message interval, then the link is considered to have
unidirectional connectivity.
udld enable (Interface Config)
Use the udld enable command in Interface (physical) Config mode to enable
UDLD on a specific interface.
Use the no form of the command to disable UDLD on an interface.
Syntax
udld enable
no udld enable
Default Configuration
UDLD is disabled by default on an interface.
Parameter Description
timeout-interval UDLD timeout interval. Range is 5 to 60 seconds.
2CSPC4.X8100-SWUM102.book Page 776 Friday, March 15, 2013 8:56 AM