1316 OSPFv3 Commands
•
seconds
— OSPF transmit delay for the specified interface. In addition, it
sets the estimated number of seconds it takes to transmit a link state
update packet over this interface. (Range: 1 to 3600 seconds)
Default Configuration
No default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transmit Delay at 100 seconds for
VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf transmit-delay 100
ipv6 router ospf
Use the ipv6 router ospf command in Global Configuration mode to enter
Router OSPFv3 Configuration mode.
Syntax
ipv6 router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
2CSPC4.X8100-SWUM102.book Page 1316 Friday, March 15, 2013 8:56 AM