Filter
Top Products
Command Groups 127
IPv6 Routing
Command Description Mode
a
clear ipv6 neighbors
Clears all entries in the IPv6 neighbor table
or an entry on a specific interface.
PE
clear ipv6 statistics
Clears IPv6 statistics for all interfaces or for a
specific interface, including loopback and
tunnel interfaces.
PE
ipv6 address
Configures an IPv6 address on an interface
(including tunnel and loopback interfaces).
IC
ipv6 enable
Enables IPv6 routing on an interface
(including tunnel and loopback interfaces)
that has not been configured with an explicit
IPv6 address.
IC
ipv6 hop-limit
Configures the hop limit used in IPv6 PDUs
originated by the router.
GC
ipv6 host
Defines static host name-to- ipv6 address
mapping in the host cache.
GC
ipv6 mld last-member-
query-count
Sets the number of listener-specific queries
sent before the router assumes that there are
no local members on the interface.
IC (VC)
ipv6 mld last-member-
query-interval
Sets the last member query interval for the
MLD interface, which is the value of the
maximum response time parameter in the
group specific queries sent out of this
interface.
IC (VC)
ipv6 mld-proxy
Enables MLD Proxy on the router. IC
ipv6 mld-proxy reset-status
Resets the host interface status parameters of
the MLD Proxy router.
IC
ipv6 mld-proxy unsolicit-
rprt-interval
Sets the unsolicited report interval for the
MLD Proxy router.
IC
ipv6 mld query-interval
Sets the MLD router's query interval for the
interface.
IC
ipv6 mld query-max-
response-time
Sets MLD querier's maximum response time
for the interface.
IC
2CSPC4.X8100-SWUM102.book Page 127 Friday, March 15, 2013 8:56 AM