OSPFv3 Commands 1341
Syntax Description
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Examples
The following examples display information about OSPF neighbors, in the
first case in a summary table, and in the second in a table specific to tunnel 1.
console#show ipv6 ospf neighbor
Router ID Priority Intf Interface State Dead
ID Time
--------- -------- ---- ----------- ------------- ----
console#show ipv6 ospf neighbor interface tunnel 1
IP Address..................................... Err
ifIndex........................................ 619
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Parameter Description
interface-type Interface type, vlan or tunnel.
interface-number A valid interface number, a valid VLAN ID or tunnel identifier.
(Range is 0-7).
neighbor-id Valid IP address of the neighbor about which information is
displayed.
2CSPC4.X8100-SWUM102.book Page 1341 Friday, March 15, 2013 8:56 AM