790 VLAN Commands
Command Mode
Global Configuration mode
User Guidelines
Commands used in the interface range context are executed independently
on each interface in the range. If the command returns an error on one of the
interfaces, an error message is displayed and execution continues on other
interfaces.
Example
The following example groups VLAN 221 through 228 and VLAN 889 to
execute the commands entered in interface range mode.
console(config)#interface range vlan 221-228,889
console(config-if)#
mode dvlan-tunnel
Use the mode dvlan-tunnel command in Interface Configuration mode to
enable Double VLAN Tunneling on the specified interface. To disable Double
VLAN Tunneling on the specified interface, use the no form of this
command.
Syntax
mode dvlan-tunnel
no mode dvlan-tunnel
Default Configuration
By default, Double VLAN Tunneling is
disabled
.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet,
fortygigabitethernet) mode
2CSPC4.X8100-SWUM102.book Page 790 Friday, March 15, 2013 8:56 AM