1242 OSPF Commands
Syntax
maximum-paths
integer
no maximum-paths
•
integer
— Number of paths that OSPF can report for a given destination.
(Range: 1–4.)
Default Configuration
4 is the
integer
default value.
Command Mode
Router OSPF Configuration mode.
User Guidelines
OSPF is only enabled on an interface if the primary IPv4 address on the
interface matches a network area range. Any individual interface can only be
attached to a single area. If an interface address matches multiple network
area ranges, the interface is assigned to the area for the first matching range.
If the ip ospf area command is given for an interface, it overrides any
matching network area command.
OSPF only advertises IP subnets for secondary IP addresses if the secondary
address is within the range of a network area command for the same area as
the primary address on the same interface.
When a network area command is deleted, matching interfaces are
reevaluated against all remaining network area commands.
Example
The following example sets the number of paths at 2 that OSPF can report
for a given destination.
console(config-router)#maximum-paths 2
network area
The network area command enables OSPFv2 on an interface and sets its area
ID if the ip-address of an interface is covered by this network command. Use
the “no” form of this command to disable OSPFv2 on an interface.
2CSPC4.X8100-SWUM102.book Page 1242 Friday, March 15, 2013 8:56 AM