Filter
Top Products
PowerConnect B-Series FCX Configuration Guide 949
53-1002266-01
Configuring OSPF
29
NOTE
Redistribution is permitted for all routes by default, so the permit redistribute 1 all command in the
example above is shown for clarity but is not required.
You also have the option of specifying import of just OSPF, BGP4, or static routes, as well as
specifying that only routes for a specific network or with a specific cost (metric) be imported, as
shown in the following command syntax.
Syntax: deny | permit redistribute <filter-num> all | bgp | connected | rip | static
[address <ip-addr> <ip-mask> [match-metric <value> [set-metric <value>]]]
Example
To redistribute RIP, static, and BGP4 routes into OSPF, enter the following commands on the Layer 3
Switch acting as an ASBR.
PowerConnectASBR(config)#router ospf
PowerConnectASBR(config-ospf-router)#permit redistribute 1 all
PowerConnectASBR(config-ospf-router)#write memory
Syntax: deny | permit redistribute <filter-num> all | bgp | connected | rip | static
address <ip-addr> <ip-mask>
[match-metric <value> | set-metric <value>]
NOTE
Redistribution is permitted for all routes by default, so the permit redistribute 1 all command in the
example above is shown for clarity but is not required.
You also have the option of specifying import of just OSPF, BGP4, or static routes, as well as
specifying that only routes for a specific network or with a specific cost (metric) be imported, as
shown in the following command syntax.
For example, to enable redistribution of RIP and static IP routes into OSPF, enter the following
commands.
PowerConnect(config)#router ospf
PowerConnect(config-ospf-router)#redistribution rip
PowerConnect(config-ospf-router)#redistribution static
PowerConnect(config-ospf-router)#write memory
Syntax: [no] redistribution bgp | connected | rip | static [route-map <map-name>]
NOTE
The redistribution command does not perform the same function as the permit redistribute and
deny redistribute commands. The redistribute commands allow you to control redistribution of
routes by filtering on the IP address and network mask of a route. The redistribution commands
enable redistribution for routes of specific types (static, directly connected, and so on). Configure
all your redistribution filters before enabling redistribution.
NOTE
Do not enable redistribution until you have configured the redistribution filters. If you enable
redistribution before you configure the redistribution filters, the filters will not take affect and all
routes will be distributed.