Filter
Top Products
Galaxy 65 User Guide
214
H.2 Configuring the LAN Settings
You can configure several LAN settings for each SM using the Disk Array Administrator software:
• IP settings (see page 214)
• FTP settings (see page 215)
• Telnet settings (see page 215)
• SNMP settings (see page 216)
• Contact settings (see page 217)
• HTTP settings (see page 218)
• Security options (see page 218)
• Reset LAN Subsystem (see page 219)
H.2.1 Configuring the IP Settings
You can set three IP-related settings:
•
IP Address
: Internet Protocol address of the SM module. Factory default is 10.0.0.1. You need
two IP addresses, one for each SM module.
• IP Mask: Subnet mask. Factory default is 255.255.255.0.
• Gateway: Optional Factory default is 0.0.0.0. See your LAN administrator for more information.
If you are not sure what IP address, subnet mask, and gateway to use, contact your LAN administrator.
Record the IP addresses, IP mask, and gateway below:
• IP address for SM module A ____________________
• IP address for SM module B ____________________
• IP mask ____________________
• Gateway ____________________
To set the IP address, subnet mask, or gateway:
1 From the System Menu, select Configuration Menu and press Enter.
The Configuration Menu displays.
2 Select LAN Configuration and press Enter.
The LAN Configuration screen displays.
3
Select
IP Settings
and press
Enter
.
The IP Settings screen displays.