Filter
Top Products
Galaxy 65 User Guide
40
5.1 Configuring the LAN-related Settings
You can configure several LAN-related settings for the Galaxy 65 Subsystem:
• IP settings (refer to the Galaxy 65 Subsystem Getting Started Guide)
• Telnet settings (see page 40)
• SNMP settings (see page 40)
• System information (see page 41)
• Passwords (see page 41)
• Security options (see page 42)
5.1.1 Configuring the Telnet Timeout
You can set the Telnet timeout setting, which controls the number of idle minutes before the Telnet
session times out. The default is no timeout, which is shown as 0 minutes.
To set the Telnet timeout:
1 In SAM, select Manage Galaxy 65 Subsystem > General Config > LAN Configuration.
The LAN Configuration page displays.
2 In the Telnet Configuration panel, enter the timeout period.
3 Click Change LAN Configuration.
5.1.2 Configuring the SNMP Settings
You can set four Simple Network Management Protocol (SNMP)-related settings:
• Traps Enabled: On or off toggle to enable SNMP traps. The default is No (disabled).
• SNMP Trap Host: Host computer’s IP address that is set up to receive SNMP traps. The default is
0.0.0.0.
• Trap Filter: Informational, Warning, or Error. The default is Warning.
• Event Filter: Informational, Warning, or Error. The default is Warning.
To set the SNMP settings:
1 In SAM, select Manage Galaxy 65 Subsystem > General Config > LAN Configuration.
The LAN Configuration page displays.
2 In the SNMP Configuration panel, select the options you want.
3 Click Change LAN Configuration.