Ricoh 2015 All in One Printer User Manual


 
Key Operator Setting
90
7
Note
You can program up to 24 charac-
ters for the sender.
You can check Own Name and
Own Fax Number using the Jour-
nal. You can check programmed
Special Senders using the specified
sender list. See p.21 Printing the
Journal. See p.96 Printing the
Special Sender List.
If you set "Authorized Reception"
to "Off for the Special Sender
function in Initial Set Up, the set-
tings will be the same as the Recep-
tion Settings. See p.73 Reception
Settings.
You cannot use the following func-
tions with Internet Fax receptions.
Authorized Reception
Memory Lock
To use the Forwarding, with Inter-
net Fax receptions, program the e-
mail address of the sender.
To search by partial matching, en-
ter the first charactors of the E-mail
address (up to the 24th) to use as
the destination name.
Authorized Reception
Use this function to limit incoming
senders. The machine only re-
ceives faxes from programmed
Special Senders, and therefore, it
helps you screen out unwanted
messages, such as junk mail, and
saves wasting fax paper.
Note
To use this function, program
the Special Senders function,
and then select On in Au-
thorized Reception with Re-
ception Settings. See p.73
Reception Settings. See p.80
User Parameters (switch 08,
bit 2).
Without programming Special
Senders, the Authorized RX
function will not work, even if
you select On.
You can select to receive only
from programmed senders or
receive only from senders other
than those programmed in User
Parameters. See p.80 User Pa-
rameters (switch 08, bit 2).
You can change Special Senders
in the same way as you pro-
gram them.
Forwarding
Use this function to print received
messages, and then transfer them
to those receivers programmed be-
forehand.
It is also possible to forward faxes
sent only by senders programmed
as Special Senders.
Note
If the special sender setting is
incorrect, Memory Transmis-
sion will not be made, even
though Forwarding appears
on the standby display.
To use this function, program
your Special Senders, and then
select On for Forwarding in
Reception Settings. See p.73
Reception Settings.
If you specify On in Forward-
ing and select
[Same as Basic Set-
tings]
, the fax message will be
forwarded to the other ends pro-
grammed in Specify End Re-
ceiver. See
p.76 Forwarding.
If you do not program any Spe-
cial Senders, the machine trans-
fers all incoming documents to
the other end specified in Spec-
ify End Receiver.
You can program e-mail ad-
dress as the receiver.
Kir-C2-AEcombine_F_FM.book Page 90 Monday, September 29, 2003 11:39 AM