Ricoh 2015 All in One Printer User Manual


 
Appendix
124
9
NetWare Printing
Form feed
You should not configure form feed
on NetWare. Form feed is controlled
by the printer driver on Windows. If
NetWare form feed is configured, the
printer might not work properly. If
you want to change form feed set-
tings, always configure them using
Windows.
Under Windows 95/98/Me, clear
the [Form feed] check box on the
[Printer Settings] tab in the printer
properties dialog box.
Under Windows 2000/XP, clear
the [Form feed] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
Under Windows NT 4.0, clear the
[Form feed] check box on the [Net-
Ware Settings] tab in the printer
properties dialog box.
Banner page
You should not configure a banner
page on NetWare. If you want to
change the banner page setting, al-
ways configure it using Windows.
Under Windows 95/98/Me, clear
the [Enable banner] check box on the
[Printer Settings] tab in the printer
properties dialog box.
Under Windows 2000/XP, clear
the [Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
Under Windows NT 4.0, clear the
[Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
Printing after resetting the machine
After resetting the remote printer, the
connection from the print server will
be cut off for about 30-40 seconds be-
fore re-connecting. Depending on the
NetWare specification, print jobs may
be accepted, but they will not be
printed during this interval.
When using the machine as a remote
printer, wait about two minutes after
resetting before attempting to print.
When Using IPP with
SmartDeviceMonitor for Client
When using IPP with SmartDevice-
Monitor for Client, note the follow-
ing:
The network printer can only re-
ceive one print job from SmartDe-
viceMonitor for Client at a time.
While the network printer is print-
ing, another user cannot access it
until the job is finished. In this
case, SmartDeviceMonitor for Cli-
ent tries to access the network
printer until the retry interval ex-
pires.
If SmartDeviceMonitor for Client
cannot access the network printer
and times out, it will stop sending
the print job. In this case, you
should cancel the paused status
from the print queue window.
SmartDeviceMonitor for Client
will resume access to the network
printer. You can delete the print
job from the print queue window,
but canceling a print job printed by
the network printer might cause
the next job sent from another user
to be incorrectly printed.