Ricoh 2015 All in One Printer User Manual


 
Appendix
92
9
Note
Enter the printer name using up to
15 characters.
You cannot use a printer name
starting with RNP or rnp.
The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
WINS
Use the wins command to config-
ure WINS server settings.
Viewing setting
The following command displays
the WINS server IP address:
msh> wins
Example output:
msh> wins
WINS Configuration:
interface_name:
WINS: On
primary server 0.0.0.0
secondary server 0.0.0.0
ScopeID
Current configuration:
primary server 0.0.0.0
secondary server 0.0.0.0
hostname host_name Sco-
peID
Note
If the IP address obtained from
DHCP differs from the WINS IP
address, the DHCP address is
the valid address.
Configuration
Use the set command to make
WINS active or inactive.
msh> wins interface_name
{on | off}
•“on means active; off means
inactive.
Setting WINS Server Address
You can make settings for the
WINS server address.
msh> wins interface_name
{primary|secondary}
IP_address
•“primary is for setting the pri-
mary WINS server address.
•“secondary is for setting the
secondary WINS server ad-
dress.
NBT scope ID setting
You can configure the NBT scope
ID.
Limitation
Enter a scope ID using up to 31
alphanumeric characters.
msh> wins interface_name
scope scope_ID
Note
If you receive different scope
IDs from DHCP and WINS, the
scope ID from DHCP takes pri-
ority.
*1
Available when the optional
802.11b interface unit is installed.
*2
Available when the optional 1394
interface board is installed.
Interface
name
Interface to be config-
ured
ether Ethernet interface
wlan
*1
IEEE 802.11b interface
ip1394
*2
IEEE 1394 interface