Filter
Top Products
3.5 <
Getting Started>
8 Select the name of your printer and click .
Note
If you cannot find your printer name, click to refresh the
list.
9 Enter the network interface's MAC address, IP address, subnet
mask, default gateway, and then click Apply.
Note
If you do not know the network interface's MAC address,
print the machine's network information report. (
See
page 13.1 for "Printing a machine report")
10 Click OK to confirm the settings.
11 Click Exit to close the SetIP program.
Altitude adjustment
The print quality is affected by atmospheric pressure, which is determined
by the height of the machine above sea level. The following information
will guide you on how to set your machine to the best print quality or best
quality of print.
Before you set the altitude value, find the altitude where you are using the
machine.
1 Press Machine Setup on the control panel.
2 Press Admin Setting.
3 When the login message appears, enter password with number
keypad and press OK. (Page
3.5)
4 Press the General tab.
5 Press Altitude Adjustment.
0
Value
Normal
High 1
High 2
High 3
6 Select appropriate option, and then click OK.
Note
Log in to the SyncThru™ Web Service as an administrator.
(
see page 13.9.)
Click Settings > Machine Settings > System > Setup >
Altitude Adj.
Machine's basic settings
After installation is complete, you may want to set the machine's default
settings. Check the next explanation if you would like to set or change
values.
Setting the authentication password
To set your machine up or change the settings, you have to login. To
change password, follow the next steps.
1 Press Machine Setup on the control panel.
2 Press Admin Setting.
3 When the login message appears, enter password. Touch the
password input area, then the question marks appears, use the
number keypad on the control panel to enter the password. Then,
press OK. (Factory setting:1111)
4 Press the Setup tab > Security
5 Press
Change Admin. Password
.
6 Enter old and new password, and then confirm the new password.
7 Press OK.
Setting the date and time
When you set the time and date, they are used in Delay fax and Delay
Print, also they are printed on reports. If, however, they are not correct,
you need to change it for correct time being.
1 Press Machine Setup on the control panel.
2 Press Admin Setting.