Filter
Top Products
Chapter 8 Major Subassemblies 8-3
FIGURE 8-1 Removing and Replacing the Power Supply (Part 1 of 2)
8.1.2 Replacing the Power Supply
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the power supply as follows (
FIGURE 8-1 and FIGURE 8-2):
a. Feed the power supply cables through the chassis opening; support the power
supply cables while engaging the power supply into the chassis rails.
b. Position the power supply into the chassis.
c. Slide the power supply toward the chassis front.
d. Connect the power cables to the motherboard.
e. Connect the peripheral cable connector to the power supply.
f. Replace the peripheral power cable through the cable routing clips.
Peripheral power cable
Captive screw (4)
Power supply
(partially extended)