Filter
Top Products
8-12 Sun Ultra 60 Service Manual • August 2001
8.4.2 Replacing the Peripheral Power Cable Assembly
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the peripheral power cable assembly into the chassis.
2. Replace the peripheral power cable through the cable routing clips.
3. Connect the following:
a. Replace the peripheral power cable connector to the hard drive SCSI
subassembly.
b. Replace the peripheral power cable connector to the CD-ROM drive (or tape
drive) and the diskette drive.
c. Replace the drive tray.
See Section 9.2.6, “Replacing the RMA” on page 9-9.
d. Replace the peripheral power cable connector to the power supply.
4. Connect the AC power cord.
5. Detach the wrist strap.
6. Replace the side access cover.
See Section 7.3, “Replacing the Side Access Cover” on page 7-4.
7. Power on the system unit.
See Section 6.1, “Powering On the System Unit” on page 6-2.
8.4.3 Removing the Diskette Drive Cable Assembly
1. Power off the system unit.
See Section 6.2, “Powering Off the System Unit” on page 6-3.
2. Remove the side access cover.
See Section 7.1, “Removing the Side Access Cover” on page 7-2.