Filter
Top Products
9-8 Sun Ultra 60 Service Manual • August 2001
9.2.3 Replacing the CD-ROM Drive or Any X-Option
Tape Drive
Note – If installing a CD-ROM drive or any X-option tape drive (verses replacing),
ensure that the peripheral power cable and all data cables are properly routed
through the clips adjacent to the drive bay. Route the SCSI data cable through both
plastic spring clips installed adjacent to the hard disk drive bay.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the CD-ROM drive or tape drive into the RMA (
FIGURE 9-3).
2. Using a number 2 Phillips-head screwdriver, replace the four screws securing the
CD-ROM drive or tape drive to the RMA.
3. Replace the RMA.
See Section 9.2.6, “Replacing the RMA” on page 9-9.
9.2.4 Removing the Diskette Drive
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the diskette drive.
2. Using a number 2 Phillips-head screwdriver, remove the four screws securing the
diskette drive to the RMA (
FIGURE 9-3).
3. Remove the diskette drive and place it on an antistatic mat.