Filter
Top Products
Chapter 8 Major Subassemblies 8-13
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
3. Attach the wrist strap.
See Section 7.2, “Attaching the Wrist Strap” on page 7-3.
4. Disconnect the diskette drive cable assembly as follows:
a. Partially remove the drive tray.
See Section 9.2.1, “Removing the RMA” on page 9-4.
b. Disconnect the SCSI cable from the CD-ROM drive (or tape drive) and unfeed
the cable through the chassis opening to expose the diskette drive cable
(underneath).
c. Remove the diskette drive cable connector from the diskette drive.
d. Remove the diskette drive cable from the plastic spring clips installed adjacent
to the drive bay.
e. Remove the diskette drive cable connector from the motherboard.
5. Remove the diskette drive cable assembly.
8.4.4 Replacing the Diskette Drive Cable Assembly
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the diskette drive cable assembly into the chassis.
2. Connect the following:
a. Replace the diskette drive cable connector to the motherboard.
b. Replace the diskette drive cable into the plastic spring clips installed adjacent
to the drive bay.
c. Replace the diskette drive cable connector to the diskette drive.
d. Connect the SCSI cable to the CD-ROM drive (or tape drive).