Sun Microsystems 60 Computer Hardware User Manual


 
Chapter 10 Motherboard and Component Replacement 10-23
10.7.2 Replacing a Motherboard
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
Caution Handle the motherboard by the handle, back panel, or the edges only.
Note Jumpers J2604 and J2605 can be set to either RS-423 or RS-232 serial
interface. The jumpers are preset for RS-423. RS-232 is required for digital
telecommunication within the European Community.
1. Using long-nose pliers, set the motherboard serial port jumpers J2604 and J2605
(
TABLE 10-2 and FIGURE 10-9).
Caution Handle the motherboard by the handle, back panel, or the edges only.
2. Place the motherboard on an antistatic mat.
TABLE 10-2 Serial Port Jumper Settings
Jumper Pins 1 + 2 Select Pins 2 + 3 Select
Default Shunt
on Pins
J2604 RS-232 RS-423 2 + 3
J2605 RS-232 RS-423 2 + 3