Filter
Top Products
Chapter 8 Major Subassemblies 8-33
c. Connect the SCSI cables.
d. If necessary, replace the RMA (refer to Section 9.2 in the Sun Ultra 60 Service
Manual.
e. Feed the peripheral power cable through the chassis opening.
f. Route the diskette drive cable through the plastic spring clips installed
adjacent to the drive bay.
g. Route the peripheral power cable through the cable routing clips.
h. Connect the peripheral power cable.
6. Replace the hard drive(s) (
FIGURE 8-16):
See Section 9.1.2, “Replacing a Hard Drive” on page 9-3.
Caution – Ensure that the hard drive is firmly seated into the system unit SCSI
connector.
7. Replace the PCI fan assembly (
FIGURE 8-15):
a. Lower the PCI fan assembly into the chassis and move it over and toward the
chassis front.
b. Align the PCI fan assembly studs with the chassis slots and engage.
c. Press the locking snap and engage to lock the fan assembly in place.
d. Connect the PCI fan power harness connector to the motherboard.
8. Replace any long PCI cards or UPA graphics cards (
FIGURE 8-13 and FIGURE 8-14).
See Section 10.3.2, “Replacing a PCI Card” on page 10-9.
9. Connect the AC power cord.
10. Detach the wrist strap.
11. Replace the side access cover (
FIGURE 8-21).
See Section 7.3, “Replacing the Side Access Cover” on page 7-4.