Filter
Top Products
10-26 Sun Ultra 60 Service Manual • August 2001
5. Connect the AC power cord.
6. Detach the wrist strap.
7. Replace the side access cover.
See Section 7.3, “Replacing the Side Access Cover” on page 7-4.
8. Reset the #power-cycles NVRAM variable to zero as follows:
a. Power on the system unit.
See Section 6.1, “Powering On the System Unit” on page 6-2.
b. Press the keyboard Stop and A keys after the system banner appears on the
monitor.
c. At the ok prompt, type:
d. Verify the #power-cycles NVRAM variable increments each time the system
unit is power cycled.
Note – The Solaris operating environment Power Management software uses the
#power-cycles NVRAM variable to control the frequency of automatic system
shutdown if automatic shutdown is enabled.
ok setenv #power-cycles 0