Filter
Top Products
10-12 Sun Ultra 60 Service Manual • August 2001
c. Lower the UPA graphics card connector so that it touches its associated UPA
card slot on the motherboard.
Caution – Avoid damaging the connector by not applying force to one end or one
side of the board.
Note – The UPA graphics card connector is a double-row connector that requires
two levels of insertion. When installing the graphics card, ensure that the connector
is fully seated into the slot.
d. At the two upper corners of the card, push the card straight down into the slot
until the card is fully seated.
e. Using a Phillips-head screwdriver, replace the screw securing the card bracket
tab to the system unit chassis.
2. Connect the AC power cord.
3. Detach the wrist strap.
4. Replace the side access cover.
See Section 7.3, “Replacing the Side Access Cover” on page 7-4.
5. Connect the video cable to the graphics card video connector.
6. Power on the system unit.
See Section 6.1, “Powering On the System Unit” on page 6-2.
10.5 DIMM
To remove and replace a DIMM, proceed as follows.
Caution – DIMMs consist of electronic components that are extremely sensitive to
static electricity. Ordinary amounts of static electricity from clothing or work
environment can destroy the DIMM.
Caution – When removing a DIMM, an identical replacement is required. The
replacement DIMM must be inserted into the same socket as the removed DIMM.